1. Before the centrifuge runs, the power should be cut off first and the brakes of the centrifuge should be released first.
2. Check other parts for looseness and abnormal conditions;
3. Turn on the power and start up in a clockwise direction (it usually takes about 40-60 seconds from the static state to normal operation);
4. Normally, after each equipment arrives at the factory, it must run for about 3 hours without any abnormal conditions.
5. Materials should be placed evenly as far as possible;
6. It must be operated by special personnel, and the capacity shall not exceed the quantity.
7. Overspeed operation of the machine is strictly prohibited to avoid affecting the service life of the machine;
8. After the machine is started, if there is any abnormal situation, it must be stopped for inspection, and if necessary, it should be taken apart, washed and repaired;
9. The centrifuge operates at high speed, so do not touch the drum with your body to prevent accidents;
10. The mesh number of the filter cloth should be determined according to the size of solid particles of the separated material, otherwise the separation effect will be affected.
11. Press cloth shall be installed when the press cloth is installed; The sealing ring is inserted into the drum sealing groove to prevent the material from running in;
12. To ensure the normal operation of the centrifuge, please refuel and maintain the rotating parts every six months.
13. At the same time, check the running lubrication of the bearing, whether there is any wear phenomenon;
14. Whether the parts in the braking device are worn or not, and the parts shall be replaced seriously; There is no oil leakage in the bearing cover;
15. Clean the machine after use and keep it clean;
16. Do not separate the non-anticorrosive centrifuge from highly corrosive materials;
17. In addition, it shall be operated in strict accordance with equipment requirements and regulations. Non-explosion-proof centrifuge shall not be used in inflammable or explosive occasions.
